Measurement and Instrumentation In an Anderson bridge, the unknown inductance is measured in terms of Known inductance and resistance Known resistance Known capacitance and resistance Known inductance Known inductance and resistance Known resistance Known capacitance and resistance Known inductance ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A resistance of 105 ohms is specified using significant figures as indicated below : 1. 105 ohms 2. 105.0 ohms 3. 0.000105 mega ohms Among these, 1 represents greater precision than 2 and 3. 2 and 3 represent greater precision than 1. 2 represents greater precision but 1 and 3 represent same precision. 1, 2 and 3 represent same precision. 1 represents greater precision than 2 and 3. 2 and 3 represent greater precision than 1. 2 represents greater precision but 1 and 3 represent same precision. 1, 2 and 3 represent same precision. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A sinusoidal signal waveform, when observed on an oscilloscope, has a peak to peak amplitude of 6 cm. If the vertical sensitivity setting is 5 v/cm, then rms value of the voltage will be 10.6 V. 12.6 V. 15 V. 11.1 V. 10.6 V. 12.6 V. 15 V. 11.1 V. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation With a sweep time 10ms across the screen the approx. horizontal sawtooth frequency will be 50Hz 100Hz 500Hz 1kHz 50Hz 100Hz 500Hz 1kHz ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A galvanometer with a full scale current of 10 mA has a resistance of 1000 Ω. The multiplying power (the ratio of measured current to galvanometer current) of 100 Ω shunt with this galvanometer is 10. 11. 100. 110. 10. 11. 100. 110. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Purely mechanical instrument cannot be used for dynamic measurements because they have high inertia. higher response time. large time constant. All of these high inertia. higher response time. large time constant. All of these ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS