Process Control and Instrumentation In a single tank system, the transfer function of __________ to inlet flow rate is 1/TS+1. Outlet flow rate Neither A nor B Here Both A & B Here Level Outlet flow rate Neither A nor B Here Both A & B Here Level ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation A non-linear system will have __________ steady state values. One Two More than one Three One Two More than one Three ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation The transfer function of a process is 1/(16s² + 8s + 4). If a step change is introduced into the system, then the response will be Under damped Over damped Critically damped None of these Under damped Over damped Critically damped None of these ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Strain gage uses an electrical conductor wire, which when elastically stretched increases in length and reduces in diameter. Both these dimensional changes result in __________ in the electrical resistance of the wire. Increase No change Decrease Exponential decrease Increase No change Decrease Exponential decrease ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Hot wire anemometer is used for the measurement of Very high temperature Flow rates of granular solids Flow rates of fluids Thermal conductivity of gases Very high temperature Flow rates of granular solids Flow rates of fluids Thermal conductivity of gases ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Conversion formula for converting amplitude ratio (AR) into decibels is Decibel = 20 log10 (AR) Decibel = 20 loge (AR)0.5 Decibel = 20 log10 (AR)0.5 Decibel = 20 loge (AR) Decibel = 20 log10 (AR) Decibel = 20 loge (AR)0.5 Decibel = 20 log10 (AR)0.5 Decibel = 20 loge (AR) ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS