Manufacturing And Production Technology In a shaper Work is stationary and tool reciprocates Tool is stationary and work reciprocates Tool moves over stationary work Tool moves over reciprocating work Work is stationary and tool reciprocates Tool is stationary and work reciprocates Tool moves over stationary work Tool moves over reciprocating work ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Flank wear occurs mainly on the Front face only Cutting edge only Face of the cutting tool at a short distance from the cutting edge Nose part, front relief face and side relief face of the cutting tool Front face only Cutting edge only Face of the cutting tool at a short distance from the cutting edge Nose part, front relief face and side relief face of the cutting tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a center lathe, the cutting tool is fed in ___ with reference to the lathe axis. Both cross and longitudinal direction Any direction Cross direction only Longitudinal direction only Both cross and longitudinal direction Any direction Cross direction only Longitudinal direction only ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In determining the various forces on the chip, Merchant assumed that the Cutting edge of the tool is sharp and it does not make any flank contact with the workpiece Cutting velocity remains constant Only continuous chip without built-up-edge is produced All of these Cutting edge of the tool is sharp and it does not make any flank contact with the workpiece Cutting velocity remains constant Only continuous chip without built-up-edge is produced All of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The increase in depth of cut and feed rate _________ surface finish. None of these Does not effect Improves Deteriorates None of these Does not effect Improves Deteriorates ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The correct sequence of the following parameters in order of their maximum to minimum influence on tool life is Feed rate, depth of cut, cutting speed Feed rate, cutting speed, depth of cut Depth of cut, cutting speed, feed rate Cutting speed, feed rate, depth of cut Feed rate, depth of cut, cutting speed Feed rate, cutting speed, depth of cut Depth of cut, cutting speed, feed rate Cutting speed, feed rate, depth of cut ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS