Workshop Technology If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be 10 mm/m 16 mm/m 26 mm/m 20 mm/m 10 mm/m 16 mm/m 26 mm/m 20 mm/m ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The width of slot cut by a hacksaw blade is ___ the width of the blade. Equal to None of the listed here Less than Greater than Equal to None of the listed here Less than Greater than ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A basic hole is one whose Lower deviation is zero None of these Upper deviation is zero Lower and upper deviations are zero Lower deviation is zero None of these Upper deviation is zero Lower and upper deviations are zero ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A pattern maker's shrinkage rule considers All pattern allowances All materials to be cast All materials of the pattern Only shrinkage allowance All pattern allowances All materials to be cast All materials of the pattern Only shrinkage allowance ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Thermit, used in Thermit welding, is a mixture of Charcoal and iron oxide Charcoal, iron oxide and aluminium Iron oxide and aluminium Charcoal and aluminium Charcoal and iron oxide Charcoal, iron oxide and aluminium Iron oxide and aluminium Charcoal and aluminium ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Tandem drawing of wires and tubes is necessary because It is not possible to reduce at one stage Annealing is needed between stages Surface finish improves after every drawing stage Accuracy in dimensions is not possible otherwise It is not possible to reduce at one stage Annealing is needed between stages Surface finish improves after every drawing stage Accuracy in dimensions is not possible otherwise ANSWER DOWNLOAD EXAMIANS APP