Measurement and Instrumentation For the AC bridge circuit shown in figure at balance the value of Rd will be (Ra/Rc).Rb. (Rc/Rb).Ra. (Rc/Ra).Rb. (Rb/Rc).Ra. (Ra/Rc).Rb. (Rc/Rb).Ra. (Rc/Ra).Rb. (Rb/Rc).Ra. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation When checked with an ohm meter an open resistor reads high but within tolerance. low but not zero. zero. infinite. high but within tolerance. low but not zero. zero. infinite. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Ratio of readings of two wattmeter connected to measure power in a balanced 3-phase load is 5:3 and the load is inductive. The power factor at load is 0.917 lead. 0.6 lag. 0.6 lead. 0.917 lag. 0.917 lead. 0.6 lag. 0.6 lead. 0.917 lag. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation If an inductance L is connected in one arm of bridge and resistance R1, R2, R3 in other three arms The bridge can be balanced. The bridge is balanced for some specified value of frequency. The bridge is balanced for some specified value of R1, R2, R3. The bridge can not be balanced. The bridge can be balanced. The bridge is balanced for some specified value of frequency. The bridge is balanced for some specified value of R1, R2, R3. The bridge can not be balanced. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation An ammeter of range 0-25 A has a guaranteed accuracy of 1% of full-scale reading. The current measured by the ammeter is 5 A. The limiting error in the reading is 4% 6% 3% 5% 4% 6% 3% 5% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Piezoelectronic accelerometer Should use a monitoring source at low input impedance. Has a low natural frequency. Should be used for low frequency. Should be used for high frequencies above 100 Hz. Should use a monitoring source at low input impedance. Has a low natural frequency. Should be used for low frequency. Should be used for high frequencies above 100 Hz. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS