Computer Networking For data communications to occur, the communicating devices must be part of a communication system made up of a combination of? Hardware and software All of these WAN and LAN Full duplex and half duplex Hardware and software All of these WAN and LAN Full duplex and half duplex ANSWER DOWNLOAD EXAMIANS APP
Computer Networking A 6-MHz channel is used by a digital signaling system utilizing 4-level signals. What is the maximum possible transmission rate? 1.5 Mbaud/sec None of these 6 Mband/sec 12 Mbaud/sec 24 Mbaud/sec 1.5 Mbaud/sec None of these 6 Mband/sec 12 Mbaud/sec 24 Mbaud/sec ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which three statements are true about the operation of a full-duplex Ethernet network?1. There are no collisions in full-duplex mode.2. A dedicated switch port is required for each full-duplex node.3. Ethernet hub ports are preconfigured for full-duplex mode.4. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.5. The host network card and the switch port must be capable of operating in full-duplex mode. 5 only 2, 3 and 4 2 and 4 1, 2, and 5 5 only 2, 3 and 4 2 and 4 1, 2, and 5 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The systematic access of small computers in a distributed data processing system is referred to as: None of these conversational mode multiplexing polling dialed service None of these conversational mode multiplexing polling dialed service ANSWER DOWNLOAD EXAMIANS APP
Computer Networking You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information? show ip eigrp interfaces show ip eigrp topology show ip eigrp neighbors show ip eigrp adjacency show ip eigrp interfaces show ip eigrp topology show ip eigrp neighbors show ip eigrp adjacency ANSWER DOWNLOAD EXAMIANS APP
Computer Networking When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured? The local DLCI on each subinterface The Frame Relay encapsulation on the physical interface An IP address on the physical interface PAP The subinterface type as point-to-point The local DLCI on each subinterface The Frame Relay encapsulation on the physical interface An IP address on the physical interface PAP The subinterface type as point-to-point ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS