Computer Networking What is the name of the device that connects two computers by means of a telephone line? Tape cable None of these bus modem Tape cable None of these bus modem ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What information is displayed by the show hosts command?1. Temporary DNS entries2. The names of the routers created using the hostname command3. The IP addresses of workstations allowed to access the router4. Permanent name-to-address mappings created using the ip host command5. The length of time a host has been connected to the router via Telnet 1 and 4 1, 2 and 3 3, 4, and 5 All of these 1 and 4 1, 2 and 3 3, 4, and 5 All of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The network layer, in reference to the OSI model, provide the interface between the X.25 network and packet mode device the virtual circuit interface to packet-switched service All of these data link procedures that provide for the exchange of data via frames that can be sent and received None of these the interface between the X.25 network and packet mode device the virtual circuit interface to packet-switched service All of these data link procedures that provide for the exchange of data via frames that can be sent and received None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What type of RJ45 UTP cable do you use to connect a PC's COM port to a router or switch console port? Rolled Crossover with a CSU/DSU Straight-through Crossover cable Rolled Crossover with a CSU/DSU Straight-through Crossover cable ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What are two purposes for segmentation with a bridge?1. To add more broadcast domains.2. To create more collision domains.3. To add more bandwidth for users.4. To allow more broadcasts for users. 2 and 3 2 and 4 1 only 4 only 2 and 3 2 and 4 1 only 4 only ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.2. The VTP management domain name of both switches must be set the same.3. All ports on both the switches must be set as access ports.4. One of the two switches must be configured as a VTP server.5. A rollover cable is required to connect the two switches together.6. A router must be used to forward VTP traffic between VLANs. 1, 2 and 4 1 and 6 3, 5 and 6 2 and 4 1, 2 and 4 1 and 6 3, 5 and 6 2 and 4 ANSWER DOWNLOAD EXAMIANS APP