Chemical Engineering Basics First empirical temperature scale conceived is the __________ temperature scale. Absolute Celcius Farenhite Reaumer Absolute Celcius Farenhite Reaumer ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics The ratio of thermal & electrical conductivity is same for all the metals at the same temperature ; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) 1/T 1/T² T² T 1/T 1/T² T² T ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Which of the following is a boiler accessory i.e., not a boiler mounting ? Feed water pump Feed check valve Stop valve Blow off cock Feed water pump Feed check valve Stop valve Blow off cock ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics If a heat transfer surface is pock-marked with a number of cavities, then as compared to a smooth surface the heat transfer by __________ will not increase. Conduction Nucleate boiling Radiation Convection Conduction Nucleate boiling Radiation Convection ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Friction factor for fluid flow in pipe does not depend upon the Mass flow rate of fluid Pipe roughness Pipe length Fluid density & viscosity Mass flow rate of fluid Pipe roughness Pipe length Fluid density & viscosity ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics What is the effect on the performance of the economiser in the thermal power plant boiler, if the feed water temperature is very low due to preheaters being out for repairs or starving of steam supply ? Economiser tube life increases due to handling of low temperature water It results in corrosion due to the condensation on the flue gas side of the economiser tubes due to handling of low temperature water Scale formation rate on economiser tubes increases Heat transfer efficiency of economiser increases due to picking up high heat from the flue gases Economiser tube life increases due to handling of low temperature water It results in corrosion due to the condensation on the flue gas side of the economiser tubes due to handling of low temperature water Scale formation rate on economiser tubes increases Heat transfer efficiency of economiser increases due to picking up high heat from the flue gases ANSWER DOWNLOAD EXAMIANS APP