Measurement and Instrumentation Figure show an RC potentiometer to measure AC voltage. It is desire that Vo/Vi should be independent of frequency. The value of C shoud be 0.1 µF. 10 µF. 0.09 µF. 11 µF. 0.1 µF. 10 µF. 0.09 µF. 11 µF. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Potentiometer method of DC voltage measurement is more accurate than direct measurement using a voltmeter because It uses centre zero galvanometer instead of voltmeter. It loads the circuit to maximum extent. It does not load the circuit at all. It loads the circuit moderately. It uses centre zero galvanometer instead of voltmeter. It loads the circuit to maximum extent. It does not load the circuit at all. It loads the circuit moderately. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The meter constant of a single phase 240 V induction watthour meter is 400 revolutions per KWh. The speed of the meter disc for a current of 10 Amperes of 0.8 p.f lagging will be 21.1 rpm. 12.8 rpm. 16.02 rpm. 18.2 rpm. 21.1 rpm. 12.8 rpm. 16.02 rpm. 18.2 rpm. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation What is the unit of plane angle? Candela Steradian Degree Radian Candela Steradian Degree Radian ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The high torque to weight ratio in an analog indicating instrument indicates high friction loss. low friction loss. none of these. nothing related to friction loss. high friction loss. low friction loss. none of these. nothing related to friction loss. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The resistance of a circuit is measured from the relation R= P/I2, where P is the power fed into the circuit and I is the current flowing through it. If the limiting errors in the measurement of power and current are respectively ± 1.0% and ± 1.0%, then what will be the limiting error in measurement of resistance ? ± 3.0% ± 1.5% ±0.5% ±3.5% ± 3.0% ± 1.5% ±0.5% ±3.5% ANSWER DOWNLOAD EXAMIANS APP