Engineering Drawing Switches and relays should be shown in this position with no operating force or applied energy: Closed Application Offset Normal Closed Application Offset Normal ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing These types of pipes are generally connected with bell and spigot joints or flanged joints: Water and steam Gas and soil Water and gas Soil and waste Water and steam Gas and soil Water and gas Soil and waste ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________. 3/4" = 1'-0" 1/4" = 1'-0" 1" = 100' 1/8" = 1'-0" 3/4" = 1'-0" 1/4" = 1'-0" 1" = 100' 1/8" = 1'-0" ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________. Type 3 back slash and enter Type @3 Type 3 forward slash and enter Type 3 and try to use the Dynamic Input readout to find the end point Type 3 back slash and enter Type @3 Type 3 forward slash and enter Type 3 and try to use the Dynamic Input readout to find the end point ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The ________ tool on the Dimension tool bar places the length of an arch on a drawing. Radius Arc Length Arc Radius Diameter Radius Arc Length Arc Radius Diameter ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS