Measurement and Instrumentation Dynamic errors are caused by observational error human error instrument not responding fast environmental error observational error human error instrument not responding fast environmental error ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The absolute measurement of resistance is done by Bridge Method Lorenz method Rayleigh method Ohm’s law method Bridge Method Lorenz method Rayleigh method Ohm’s law method ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A dynamometer wattmeter can be used for Any of the listed here Both DC and AC DC only AC only Any of the listed here Both DC and AC DC only AC only ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A single phase load is connected between R and Y terminals of a 415 V, symmetrical, 3-phase, 4 wire system with phase sequence RYB. A wattmeter is connected in the system as shown in figure. The power factor of the load is 0.8 lagging. The wattmeter will read - 795 W. + 597 W. - 597 W. + 795 W. - 795 W. + 597 W. - 597 W. + 795 W. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Which of the following devices may be used for extending the range of instruments? Potential transformers Shunt Current transformers All of the listed here Potential transformers Shunt Current transformers All of the listed here ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Which of the following devices should be used for accurate measurement of low D.C. voltage? C. potentiometer Small range moving coil voltmeter Small range thermocouple voltmeter None of these C. potentiometer Small range moving coil voltmeter Small range thermocouple voltmeter None of these ANSWER DOWNLOAD EXAMIANS APP