Manufacturing And Production Technology Crater wear occurs mainly on the Nose part, front relief face and side relief face of the cutting tool Cutting edge only Front face only Face of the cutting tool at a short distance from the cutting edge only Nose part, front relief face and side relief face of the cutting tool Cutting edge only Front face only Face of the cutting tool at a short distance from the cutting edge only ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position. GMAW practice Globular transfer Dip transfer Spray transfer GMAW practice Globular transfer Dip transfer Spray transfer ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A 15 mm drilling machine means that it can drill a hole Of maximum diameter 15 mm In 15 mm thick plates None of these Of maximum diameter 15 mm In 15 mm thick plates None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 26.56 20.56 36.56 30.56 26.56 20.56 36.56 30.56 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology For softer materials, the point angle of the drill is kept Any one of these Less than 118° Equal to 118° More than 118° Any one of these Less than 118° Equal to 118° More than 118° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The chamfering is an operation of Enlarging the end of a hole cylindrically Reducing the diameter of a workpiece over a very narrow surface Embossing a diamond shaped pattern on the surface of a workpiece Beveling the extreme end of a workpiece Enlarging the end of a hole cylindrically Reducing the diameter of a workpiece over a very narrow surface Embossing a diamond shaped pattern on the surface of a workpiece Beveling the extreme end of a workpiece ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS