Manufacturing And Production Technology Crater wear is mainly due to the phenomenon known as All of these Adhesion of metals Diffusion of metals Oxidation of metals All of these Adhesion of metals Diffusion of metals Oxidation of metals ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Side rake angle of a single point cutting tool is the angle By which the face of the tool is inclined sideways By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined sideways By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The taper on the lathe spindle is 1 in 10 1 in 30 1 in 20 1 in 15 1 in 10 1 in 30 1 in 20 1 in 15 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A diamond locating pin is used in jigs and fixtures because It helps in assembly with tolerance on centre distance It occupies very little space It has a long life Diamond is very hard and wear resistant It helps in assembly with tolerance on centre distance It occupies very little space It has a long life Diamond is very hard and wear resistant ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A CNC vertical milling machine has to cut a straight slot of 10 mm width and 2 mm depth by a cutter of 10 mm diameter between points (0,0) and (100,100) on the XY plane (dimensions in mm). The feed rate used for milling is 50 mm/min, milling time for the slot (in seconds) is 120 180 170 240 120 180 170 240 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The high cutting speed and large rake angle of the tool will result in the formation of Continuous chips None of these Discontinuous chip Continuous chips with built up edge Continuous chips None of these Discontinuous chip Continuous chips with built up edge ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS