Manufacturing And Production Technology Crack in grinding wheel is developed due to High speed of wheel High temperature developed at the contact of the wheel face and work Low speed of wheel Grinding hard work High speed of wheel High temperature developed at the contact of the wheel face and work Low speed of wheel Grinding hard work ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Gear lapping is an operation Prior to heat treatment For gear reconditioning None of the listed here After heat treatment Prior to heat treatment For gear reconditioning None of the listed here After heat treatment ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The relation between tool life (T) and cutting speed (V) is VTn = Constant. In this relation, the value of n depends upon Type of chip produced Working conditions Tool material Work material Type of chip produced Working conditions Tool material Work material ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Larger end cutting edge angle _________ tool life. Increases Decreases Does not effect None of these Increases Decreases Does not effect None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Hard and tough materials like cast iron should be turned at Slow speed High speed Any speed Certain specific speed Slow speed High speed Any speed Certain specific speed ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology An operation of embossing a diamond shaped pattern on the surface of a workpiece, is known as Knurling Facing Counter-boring Grooving Knurling Facing Counter-boring Grooving ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS