Computer Networking Which one of the following network uses dynamic or adaptive routing? SNA(IBM's System Network Architechture) ARPANET None of these TYMNET SNA(IBM's System Network Architechture) ARPANET None of these TYMNET ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What two multicast addresses does OSPFv3 use?1. FF02::A2. FF02::93. FF02::54. FF02::6 3 and 4 1 and 3 3 only 2 only 3 and 4 1 and 3 3 only 2 only ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following is true when describing a global unicast address? These are like private addresses in IPv4 in that they are not meant to be routed. These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap. These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4. Packets addressed to a unicast address are delivered to a single interface. These are like private addresses in IPv4 in that they are not meant to be routed. These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap. These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4. Packets addressed to a unicast address are delivered to a single interface. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To enable RIPng, which of the following would you use? Router1(config-if)# ipv6 router rip 1 Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config)# ipv6 router eigrp 10 Router1(config-rtr)# no shutdown Router1(config-if)# ipv6 router rip 1 Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config)# ipv6 router eigrp 10 Router1(config-rtr)# no shutdown ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which command is used to upgrade an IOS on a Cisco router? config net copy tftp flash copy tftp run copy tftp start config net copy tftp flash copy tftp run copy tftp start ANSWER DOWNLOAD EXAMIANS APP
Computer Networking You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be? The switch port the host is connected to is not configured to the correct VLAN membership. The router is not configured for the new host. The host has an invalid MAC address. The VTP configuration on the switch is not updated for the new host. The switch port the host is connected to is not configured to the correct VLAN membership. The router is not configured for the new host. The host has an invalid MAC address. The VTP configuration on the switch is not updated for the new host. ANSWER DOWNLOAD EXAMIANS APP