Computer Networking
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?

IP addressing on the network is incorrect.
You must use the terminal monitor command.
You must type the show ip rip command first.
Debug output is sent only to the console.

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?

Add the destination to the MAC address table and then forward the frame
Add the source address and port to the MAC address table and forward the frame out the destination port
Flood the network with the frame
Discard it and send an error message back to the originating host

ANSWER DOWNLOAD EXAMIANS APP