Computer Networking
Which layer 1 devices can be used to enlarge the area covered by a single LAN segment?1. Switch2. NIC3. Hub4. Repeater5. RJ45 transceiver

1 only
3 and 4
All of these
5 only
1 and 3

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?1. Switch (config-if) # ip access-group 102. Switch (config-if) # switchport port-security maximum 13. Switch (config) # access-list 10 permit ip host 14. Switch (config-if) # switchport port-security violation shutdown5. Switch (config) # mac-address-table secure

1 and 3
2, 3 and 5
2 and 4
4 and 5

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.2. The VTP management domain name of both switches must be set the same.3. All ports on both the switches must be set as access ports.4. One of the two switches must be configured as a VTP server.5. A rollover cable is required to connect the two switches together.6. A router must be used to forward VTP traffic between VLANs.

3, 5 and 6
1, 2 and 4
1 and 6
2 and 4

ANSWER DOWNLOAD EXAMIANS APP