Machine Design When the speed of belt increases, The coefficient of friction between the belt and pulley decreases The coefficient of friction between the belt and pulley increases The power transmitted will decrease The power transmitted will increase The coefficient of friction between the belt and pulley decreases The coefficient of friction between the belt and pulley increases The power transmitted will decrease The power transmitted will increase ANSWER DOWNLOAD EXAMIANS APP
Machine Design The groove angle of the pulley for rope drive is usually 20° 60° 45° 35° 20° 60° 45° 35° ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft coupling should Be easy to connect or disconnect Hold the shafts in perfect alignment All of these Transmit full power of the shaft Be easy to connect or disconnect Hold the shafts in perfect alignment All of these Transmit full power of the shaft ANSWER DOWNLOAD EXAMIANS APP
Machine Design Stress concentration is caused due to Variation in properties of material from point to point in a member All of these Pitting at points or areas at which loads on a member are applied Abrupt change of section Variation in properties of material from point to point in a member All of these Pitting at points or areas at which loads on a member are applied Abrupt change of section ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which of the following statement is correct, for two shafts connected in parallel? Torsional stiffness of each shaft is the same Angle of twist of each shaft is the same Torque in each shaft is the same Shear stress in each shaft is the same Torsional stiffness of each shaft is the same Angle of twist of each shaft is the same Torque in each shaft is the same Shear stress in each shaft is the same ANSWER DOWNLOAD EXAMIANS APP
Machine Design In testing a material for endurance strength, it is subjected to Dynamic load Static load Completely reversed load Impact load Dynamic load Static load Completely reversed load Impact load ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS