Computer Hardware When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to: The same address as the SCSI device before the CD-ROM An unused SCSI address B0007 SCSI ID=1 None of these The same address as the SCSI device before the CD-ROM An unused SCSI address B0007 SCSI ID=1 None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware One of the major components of a PC is the Central Processing Unit (CPU) which can be best described as: The device that sends the monitor signals telling it what to display The area where ail the of the Basic input/output routines are stored The area that regulates all of the system power usage The area where all of the processing takes place The device that sends the monitor signals telling it what to display The area where ail the of the Basic input/output routines are stored The area that regulates all of the system power usage The area where all of the processing takes place ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware What is the highest binary number that can be referred to on a three position jumper block? 1 6 4 7 1 6 4 7 ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware Which I/O port belongs to LPT2? 3f8h 378H 278H None of these 2e8h 3f8h 378H 278H None of these 2e8h ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware A keyboard locks up intermittently even when replaced with a new keyboard. What is the LEAST likely cause of the problem? The keyboard connector None of these The motherboard The keyboard controller chip A second bad keyboard The keyboard connector None of these The motherboard The keyboard controller chip A second bad keyboard ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware To install a second IDE drive into a computer, you must Verify that you define the new drive as D: in the CMOS setup Set the master-slave jumper to slave on the second drive Use the IDE configuration software to set the new drive as slave Verify that you attach the drive to the connector at the end of the ribbon cable Verify that you define the new drive as D: in the CMOS setup Set the master-slave jumper to slave on the second drive Use the IDE configuration software to set the new drive as slave Verify that you attach the drive to the connector at the end of the ribbon cable ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS