Engineering Drawing When dimensioning piping drawings, you give the lengths of all runs of this type: Angular Filleted Straight Transverse Angular Filleted Straight Transverse ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Students can complete an associate's degree in drafting which normally takes about __________ years to complete. Three Two One Four Three Two One Four ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Lines of an isometric drawing that are not parallel to the isometric axes are called this: Multiview lines Non-isometric lines Dimetric lines Trimetric lines Multiview lines Non-isometric lines Dimetric lines Trimetric lines ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing If a designer is developing a plan for a project in which the entire part is made out of ¾" thick plywood and he only wants to use one view, he should use the ________ view. Back Right Top Front Back Right Top Front ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the descriptive geometry method to create an auxiliary view the drafter should _________. Rotate the snap grid to the same angle of the inclined plane Offset the top line of the front view 2 inches Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees Rotate the snap grid to the same angle of the inclined plane Offset the top line of the front view 2 inches Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches: One foot or over One inch or over One rod or over One yard or over One foot or over One inch or over One rod or over One yard or over ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS