Manufacturing And Production Technology What is the welding defect caused due to improper control and poor removal of slog between passes called? Under fill Crack Porosity Mismatch Under fill Crack Porosity Mismatch ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is correct about nose radius? Both (A) and (B) It improves tool life It improves the surface finish None of these Both (A) and (B) It improves tool life It improves the surface finish None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A single point thread cutting tool should ideally have Zero rake angle Point angle Positive rake angle Negative rake angle Zero rake angle Point angle Positive rake angle Negative rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology If the flame of the welding torch is directed towards the progress of welding, then what will you call the welding technique? Pulsed spray welding Forehand welding Electro slag welding Flux cored ARC welding Pulsed spray welding Forehand welding Electro slag welding Flux cored ARC welding ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology If the helix angle of the drill is made ________ 30°, then the torque required to drive the drill at a given feed will be more. More than Equal to Less than None of these More than Equal to Less than None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The correct sequence of the following parameters in order of their maximum to minimum influence on tool life is Depth of cut, cutting speed, feed rate Cutting speed, feed rate, depth of cut Feed rate, cutting speed, depth of cut Feed rate, depth of cut, cutting speed Depth of cut, cutting speed, feed rate Cutting speed, feed rate, depth of cut Feed rate, cutting speed, depth of cut Feed rate, depth of cut, cutting speed ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS