Computer Networking What is the standard protocol for network management features? SNMP None of these SNA FTP SMS SNMP None of these SNA FTP SMS ANSWER DOWNLOAD EXAMIANS APP
Computer Networking You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?1. Switch (config-if) # ip access-group 102. Switch (config-if) # switchport port-security maximum 13. Switch (config) # access-list 10 permit ip host 14. Switch (config-if) # switchport port-security violation shutdown5. Switch (config) # mac-address-table secure 2 and 4 4 and 5 1 and 3 2, 3 and 5 2 and 4 4 and 5 1 and 3 2, 3 and 5 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The probability that a single bit will be in error on a typical public telephone line using 4800 bps modem is 10 to the power -3. If no error detection mechanism is used, the residual error rate for a communication line using 9-bit frames is approximately equal to 0.003 0.009 0.991 0.999 None of these 0.003 0.009 0.991 0.999 None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table? The updated information will be added to the existing routing table. They will all load-balance. The existing routing table entry will be deleted from the routing table and all routers will exchange routing updates to reach convergence. The update will be ignored and no further action will occur. The updated information will replace the existing routing table entry. The updated information will be added to the existing routing table. They will all load-balance. The existing routing table entry will be deleted from the routing table and all routers will exchange routing updates to reach convergence. The update will be ignored and no further action will occur. The updated information will replace the existing routing table entry. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking If you want to disable STP on a port connected to a server, which command would you use? spanning-tree security disable spanning-tree spanning-tree off spanning-tree portfast spanning-tree security disable spanning-tree spanning-tree off spanning-tree portfast ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What part of 192.168.10.51 is the Network ID, assuming a default subnet mask? 192 0.0.0.5 None of these 51 192.168.10 192 0.0.0.5 None of these 51 192.168.10 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS