Computer Hardware
To install a second IDE drive into a computer, you must

Use the IDE configuration software to set the new drive as slave
Verify that you attach the drive to the connector at the end of the ribbon cable
Verify that you define the new drive as D: in the CMOS setup
Set the master-slave jumper to slave on the second drive

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
What is the most likely cause of an "FDD controller Failure" error message?

None of these
you forgot to flash CMOS
you did not set the jumper on the floppy drive to drive A
your computer's floppy drive is defective
you installed the floppy disk drive cable backward

ANSWER DOWNLOAD EXAMIANS APP