Computer Networking What is the minimum number of wires needed to send data over a serial communication link layer? None of these 2 1 4 6 None of these 2 1 4 6 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The data-link layer, in reference to the OSI model, specifies the virtual circuit interface to packet-switched service data link procedures that provide for the exchange of data via frames that can be sent and received All of these None of these the interface between the X.25 network and packet mode device the virtual circuit interface to packet-switched service data link procedures that provide for the exchange of data via frames that can be sent and received All of these None of these the interface between the X.25 network and packet mode device ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To enable RIPng, which of the following would you use? Router1(config)# ipv6 router eigrp 10 Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config-if)# ipv6 router rip 1 Router1(config-rtr)# no shutdown Router1(config)# ipv6 router eigrp 10 Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 Router1(config-if)# ipv6 router rip 1 Router1(config-rtr)# no shutdown ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following conditions is used to transmit two packets over a medium at the same time? Collision Contention Asynchronous None of these Synchronous Collision Contention Asynchronous None of these Synchronous ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which of the following allows devices on one network to communicate with devices on another network? multiplexer gateway None of these modern t-switch multiplexer gateway None of these modern t-switch ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which is true regarding EIGRP successor routes?1. A successor route is used by EIGRP to forward traffic to a destination.2. Successor routes are saved in the topology table to be used if the primary route fails.3. Successor routes are flagged as "active" in the routing table.4. A successor route may be backed up by a feasible successor route.5. Successor routes are stored in the neighbor table following the discovery process. 1 and 4 3, 4 and 5 1 and 3 2 and 3 1 and 4 3, 4 and 5 1 and 3 2 and 3 ANSWER DOWNLOAD EXAMIANS APP