Analog Electronics To prevent a DC return between source and load, it is necessary to use Either A or B Resistor between source and load Capacitor between source and load Inductor between source and load Either A or B Resistor between source and load Capacitor between source and load Inductor between source and load ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed 79.5 mV 795mV 395mV 39.5mV 79.5 mV 795mV 395mV 39.5mV ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Acceptors impurities are of ________ material solid Both A and B n-type p-type solid Both A and B n-type p-type ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Which of the following components are used for bias compensation in transistor circuit? Resistors. Thermistor. Rectifier diodes. Both (A) and (C) above. Resistors. Thermistor. Rectifier diodes. Both (A) and (C) above. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The emitter of the transistor is generally doped the heaviest because it has to dissipate maximum power. is the first region of transistor. must possess low resistance. has to supply the charge carriers. has to dissipate maximum power. is the first region of transistor. must possess low resistance. has to supply the charge carriers. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics In an NPN transistor, the majority carriers in the emitter are both. neither. holes. free electrons. both. neither. holes. free electrons. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS