Computer Hardware To install a second IDE drive into a computer, you must Use the IDE configuration software to set the new drive as slave Verify that you attach the drive to the connector at the end of the ribbon cable Set the master-slave jumper to slave on the second drive Verify that you define the new drive as D: in the CMOS setup Use the IDE configuration software to set the new drive as slave Verify that you attach the drive to the connector at the end of the ribbon cable Set the master-slave jumper to slave on the second drive Verify that you define the new drive as D: in the CMOS setup ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware From what location are the 1st computer instructions available on boot up? None of these boot.ini CPU ROM BIOS CONFIG.SYS None of these boot.ini CPU ROM BIOS CONFIG.SYS ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem. loose molex connector incorrect jumper setting on drive virus bad data cable tfad system board loose molex connector incorrect jumper setting on drive virus bad data cable tfad system board ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware What expansion types do most pll/plll motherboards support? MCA, PCI ISA, PCI, AGP ISA, VESA, PCI ISA, EISA MCA, PCI ISA, PCI, AGP ISA, VESA, PCI ISA, EISA ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware You have a system that periodically locks up. You have ruled out software, and now suspect that it is hardware. What should you do first that could help you narrow it down to the component at fault? replace the CPU rotate the RAM disable the CPU cache in CMOS replace the RAM replace the level 2 cache SIMM replace the CPU rotate the RAM disable the CPU cache in CMOS replace the RAM replace the level 2 cache SIMM ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware When installing an internal modem, all of the following IRQ's can be used except? 14 10 15 12 14 10 15 12 ANSWER DOWNLOAD EXAMIANS APP