Measurement and Instrumentation To increase Q factor of a coil, the wire should be thin. thick. long. long and thin. thin. thick. long. long and thin. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation For measurement of mutual inductance we can use Maxwell's bridge Heavyside bridge Anderson bridge Any of the listed here Maxwell's bridge Heavyside bridge Anderson bridge Any of the listed here ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A resistance is measured by the voltmeter-ammeter method employing dc excitation and a voltmeter of very high resistance connected directly across the unknown resistance. If the voltmeter and ammeter reading are subject to maximum possible errors of ± 2.4 % and ± 1.0 % respectively, then the magnitude of the maximum possible percentage error in the value of resistance deduced from the measurement is nearly ± 1% ± 2.4% ± 3.4% ± 1.4% ± 1% ± 2.4% ± 3.4% ± 1.4% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation In an Anderson bridge, the unknown inductance is measured in terms of Known resistance Known capacitance and resistance Known inductance and resistance Known inductance Known resistance Known capacitance and resistance Known inductance and resistance Known inductance ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A single phase load is connected between R and Y terminals of a 415 V, symmetrical, 3-phase, 4 wire system with phase sequence RYB. A wattmeter is connected in the system as shown in figure. The power factor of the load is 0.8 lagging. The wattmeter will read + 795 W. - 795 W. + 597 W. - 597 W. + 795 W. - 795 W. + 597 W. - 597 W. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation What is the approximate input impedance of a CRO? 100 MΩ 0 1 MΩ 10 MΩ 100 MΩ 0 1 MΩ 10 MΩ ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS