Computer Networking
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.2. The VTP management domain name of both switches must be set the same.3. All ports on both the switches must be set as access ports.4. One of the two switches must be configured as a VTP server.5. A rollover cable is required to connect the two switches together.6. A router must be used to forward VTP traffic between VLANs.

3, 5 and 6
1 and 6
1, 2 and 4
2 and 4

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches?

Broadcast storms will occur on the switched network.
The MAC forward/filter table will not update on the switch.
The switches will automatically load-balance between the two links.
The routing tables on the switches will not update.

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
The MAC (Media Access Control) address of the network card is used in both Ethernet and Token-Ring networks and is essential for communication. What does MAC provide?

A physical address that is assigned by the manufacturer
A physical address that is randomly assigned each time the computer is started
The logical domain address for the workstation
An alias for the computer name
A logical address that identifies the workstation

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?

Router(config-if)# encapsulation frame-relay q933a
Router(config-if)# encapsulation frame-relay ietf
Router(config-if)# encapsulation frame-relay ansi
Router(config-if)# encapsulation frame-relay cisco

ANSWER DOWNLOAD EXAMIANS APP
MORE MCQ ON Computer Networking