Manufacturing And Production Technology The swing diameter over the bed is ________ the height of the centre measured from the bed of the lathe. One-half Twice Equal to Thrice One-half Twice Equal to Thrice ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as End relief angle Back rake angle Side relief angle Side rake angle End relief angle Back rake angle Side relief angle Side rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Crater wear occurs mainly on the Face of the cutting tool at a short distance from the cutting edge only Front face only Nose part, front relief face and side relief face of the cutting tool Cutting edge only Face of the cutting tool at a short distance from the cutting edge only Front face only Nose part, front relief face and side relief face of the cutting tool Cutting edge only ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Friction at the tool-chip interface can be reduced by Decreasing the cutting speed Increasing the cutting speed Decreasing the rake angle Increasing the depth of cut Decreasing the cutting speed Increasing the cutting speed Decreasing the rake angle Increasing the depth of cut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In machining metals, surface roughness is due to All of these Feed marks or ridges left by the cutting tool Fragment of built-up edge on the machined surface Cutting tool vibrations All of these Feed marks or ridges left by the cutting tool Fragment of built-up edge on the machined surface Cutting tool vibrations ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool life is said to be over if Poor surface finish is obtained There is sudden increase in cutting forces and power consumption All of these Overheating and fuming due to heat of friction starts Poor surface finish is obtained There is sudden increase in cutting forces and power consumption All of these Overheating and fuming due to heat of friction starts ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS