Workshop Technology The shrinkage allowance for cast iron pattern is 16 mm/m 26 mm/m 20 mm/m 10 mm/m 16 mm/m 26 mm/m 20 mm/m 10 mm/m ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In forehand welding, the angle between the welding torch and the work is ________ as compared to backhand welding. Less None of these More Same Less None of these More Same ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For welding plates of thickness less than 5 mm, its edges Should have a double-V or U-groove on one side Should have a double-V or U-groove on both sides Should be bevelled to a single-V or U-groove Do not require bevelling Should have a double-V or U-groove on one side Should have a double-V or U-groove on both sides Should be bevelled to a single-V or U-groove Do not require bevelling ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For obtaining a cup of diameter 25 mm and height 15 mm by drawing, the size of the round blank should be approximately 46 mm 44 mm 48 mm 42 mm 46 mm 44 mm 48 mm 42 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The cross-section of a chisel is usually Rectangular Octagonal Square Hexagonal Rectangular Octagonal Square Hexagonal ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The process of decreasing the cross-section of a bar and increasing its length, is called Upsetting Peening Drawing down Spinning Upsetting Peening Drawing down Spinning ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS