Manufacturing And Production Technology The rear teeth of a broach Remove maximum metal Perform burnishing operation Remove minimum metal Remove no metal Remove maximum metal Perform burnishing operation Remove minimum metal Remove no metal ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The capacity of a material to be welded under the imposed fabrication conditions into a specific, suitably designed structure and to perform satisfactorily in the intended service is known as? Weld tab Weldment Weldability Tack weld Weld tab Weldment Weldability Tack weld ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tail-stock set over required to turn a taper on the entire length of a workpiece having diameters D and d is (D - d)/2 (D - d)/2L (D - d)/L D - d (D - d)/2 (D - d)/2L (D - d)/L D - d ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant) VTn = C V/Tn = C VnT = C Vn/T = C VTn = C V/Tn = C VnT = C Vn/T = C ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Climb milling is chosen while machining because It enables the cutter to dig in and start the cut The specific power consumption is reduced The chip thickness increase gradually Better surface finish can be obtained It enables the cutter to dig in and start the cut The specific power consumption is reduced The chip thickness increase gradually Better surface finish can be obtained ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A dynamo-meter is a device used for the measurement of Forces during metal cutting Chip thickness ratio Deflection of the cutting tool Wear of the cutting tool Forces during metal cutting Chip thickness ratio Deflection of the cutting tool Wear of the cutting tool ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS