Manufacturing And Production Technology The obtuse angle, included between the chisel edge and the lip as viewed from the end of a drill, is called Point angle Lip clearance angle Chisel edge angle Helix or rake angle Point angle Lip clearance angle Chisel edge angle Helix or rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A lathe with four steps on the cone pulley and with back-gears will have Eight indirect speeds Four indirect speeds Four direct and four indirect speeds Four direct speeds Eight indirect speeds Four indirect speeds Four direct and four indirect speeds Four direct speeds ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the maximum chip thickness Depends upon the material of the tool May not occur at the middle Depends upon the geometry of the tool Occurs at the middle Depends upon the material of the tool May not occur at the middle Depends upon the geometry of the tool Occurs at the middle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A right hand tool on a lathe cuts most efficiently when it travels Across the bed From left to right end of the lathe bed With the help of a compound slide From right to left end of the lathe bed Across the bed From left to right end of the lathe bed With the help of a compound slide From right to left end of the lathe bed ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The maximum possible draft in cold rolling of sheet increases with the Decrease in coefficient of friction Decrease in roll radius Decrease in roll velocity Increase in coefficient of friction Decrease in coefficient of friction Decrease in roll radius Decrease in roll velocity Increase in coefficient of friction ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Jigs are used To check the accuracy of workpiece For holding and guiding the tool in drilling, reaming or tapping operations None of these For holding the work in milling, grinding, planing or turning operations To check the accuracy of workpiece For holding and guiding the tool in drilling, reaming or tapping operations None of these For holding the work in milling, grinding, planing or turning operations ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS