Engineering Drawing The most common geometric form used in gears today is this: Spur circle Convolute profile Base circle Involute profile Spur circle Convolute profile Base circle Involute profile ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line. Horizontal Inclined Vertical None of these Horizontal Inclined Vertical None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Acceptable parts must not extend beyond this: Boundary limits Tolerances Specification Hole limits Boundary limits Tolerances Specification Hole limits ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In this type of concrete, the steel is pre-tensioned before the superimposed load is applied: Preloaded Reinforced Pre-stressed Aggregate Preloaded Reinforced Pre-stressed Aggregate ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Newer versions of Auto-CAD utilize the _________ to make block library management very easy. File / search Design Center File / find None of these File / search Design Center File / find None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In offset sections, offsets or bends in the cutting plane are all: Either 90 or 180 degrees 90 degrees 180 degrees 30, 60 or 90 degrees Either 90 or 180 degrees 90 degrees 180 degrees 30, 60 or 90 degrees ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS