Manufacturing And Production Technology The material property which depends only on the basic crystal structure is Work hardening Fracture strength Fatigue strength Elastic constant Work hardening Fracture strength Fatigue strength Elastic constant ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The chuck preferred for quick setting and accurate centering of a job is Magnetic chuck Collect chuck Three jaw universal chuck Four jaw independent chuck Magnetic chuck Collect chuck Three jaw universal chuck Four jaw independent chuck ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In the relation VTn = C, the value of n for carbide tools is 0.25 to 0.40 0.40 to 0.55 0.20 to 0.25 0.1 to 0.2 0.25 to 0.40 0.40 to 0.55 0.20 to 0.25 0.1 to 0.2 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The hole to be drilled for tapping is _________ the outside diameter of the thread on the tap. Greater than Smaller than None of the listed here Equal to Greater than Smaller than None of the listed here Equal to ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Crater wear occurs mainly on the Front face only Nose part, front relief face and side relief face of the cutting tool Face of the cutting tool at a short distance from the cutting edge only Cutting edge only Front face only Nose part, front relief face and side relief face of the cutting tool Face of the cutting tool at a short distance from the cutting edge only Cutting edge only ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is wrong as regard to down milling? The chips are disposed off easily and do not interfere with the cutting. The surface milled appears to be slightly wavy. The coolant can be poured directly at the cutting zone where the cutting force is maximum. It can not be used on old machines due to backlash between the feed screw of the table and the nut. The chips are disposed off easily and do not interfere with the cutting. The surface milled appears to be slightly wavy. The coolant can be poured directly at the cutting zone where the cutting force is maximum. It can not be used on old machines due to backlash between the feed screw of the table and the nut. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS