Manufacturing And Production Technology The angle between the lathe centres is 60° 45° 90° 30° 60° 45° 90° 30° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as End relief angle Side relief angle Back rake angle Side rake angle End relief angle Side relief angle Back rake angle Side rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Quadrupled Doubled Halved Unchanged Quadrupled Doubled Halved Unchanged ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The method of centre less grinding used to produce taper is End feed grinding Through feed grinding In-feed grinding Any one of these End feed grinding Through feed grinding In-feed grinding Any one of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The actual feed in centerless grinders is given by (where d = Dia. of regulating wheel, n = Revolutions per minute, and α = Angle of inclination of wheel) πdn sinα πdn πd πdn cosα πdn sinα πdn πd πdn cosα ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 9 10 8 7 9 10 8 7 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS