Manufacturing And Production Technology The abrasive recommended for grinding materials of high tensile strength is Aluminium oxide Silicon carbide Sand stone Diamond Aluminium oxide Silicon carbide Sand stone Diamond ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The work or surface speed for cylindrical grinding varies from 10 to 20 m/min 5 to 10 m/min 20 to 30 m/min 40 to 60 m/min 10 to 20 m/min 5 to 10 m/min 20 to 30 m/min 40 to 60 m/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The purpose of jigs and fixtures is to All of these Increase machining accuracy Facilitate interchangeability Decrease expenditure on quality control All of these Increase machining accuracy Facilitate interchangeability Decrease expenditure on quality control ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 7 9 8 10 7 9 8 10 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the maximum chip thickness Depends upon the material of the tool May not occur at the middle Depends upon the geometry of the tool Occurs at the middle Depends upon the material of the tool May not occur at the middle Depends upon the geometry of the tool Occurs at the middle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Tool signature consists of __________ elements. Two Five Four Seven Two Five Four Seven ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS