Engineering Drawing The 3-D commands on the Modeling toolbar include __________. Extrude Sphere Box All of these Extrude Sphere Box All of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line. Horizontal Inclined Vertical None of these Horizontal Inclined Vertical None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The title block used on working drawings should include the _________. Layer set All of these Line type Sheet number Layer set All of these Line type Sheet number ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When only a small section of an interior area needs to be revealed the drafter can use a ________ section. Half Full Broken out Quarter Half Full Broken out Quarter ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view. Length None of these Width Height Length None of these Width Height ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection, the oblique drawing is called this: Cavalier projection Isometric projection Cabinet projection Axonometric projection Cavalier projection Isometric projection Cabinet projection Axonometric projection ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS