Analog Electronics Suppose the base resistor is open. The Q point will be in the middle of the load line. off the load line. at the lower end of the load line. at the upper end of the load line. in the middle of the load line. off the load line. at the lower end of the load line. at the upper end of the load line. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics In a loaded zener regulator, which is the largest current? Series current. None of these Zener current. Load current. Series current. None of these Zener current. Load current. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The value of total collector electric current in a CB circuit is IC = αIE + ICO. IC = βIE. IC = αIE - ICO. IC = αIE. IC = αIE + ICO. IC = βIE. IC = αIE - ICO. IC = αIE. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Which of the following is a semiconductors material ? GaAs All the above Ge Si GaAs All the above Ge Si ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics In a zener diode shunt voltage regulator, the diode regulates so long as it is kept in ______________________ condition. unloaded. reverse. forward. loaded. unloaded. reverse. forward. loaded. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed 395mV 39.5mV 79.5 mV 795mV 395mV 39.5mV 79.5 mV 795mV ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS