Repeaters are often used on an 802.3 network to help strengthen the signals being transmitted. As with the length of segments and the number of segments, a limit exists as to how many repeaters can be used between any two nodes. What is the maximum number of repeaters that can be used?

Computer Networking
Repeaters are often used on an 802.3 network to help strengthen the signals being transmitted. As with the length of segments and the number of segments, a limit exists as to how many repeaters can be used between any two nodes. What is the maximum number of repeaters that can be used?

Five

Six

Four

Two

Three

Five

Six

Four

Two

Three

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

The local DLCI on each subinterface

PAP

The Frame Relay encapsulation on the physical interface

The subinterface type as point-to-point

An IP address on the physical interface

The local DLCI on each subinterface

PAP

The Frame Relay encapsulation on the physical interface

The subinterface type as point-to-point

An IP address on the physical interface

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
To enable RIPng, which of the following would you use?

Router1(config-rtr)# no shutdown

Router1(config)# ipv6 router eigrp 10

Router1(config-if)# ipv6 ospf 10 area 0.0.0.0

Router1(config-if)# ipv6 router rip 1

Router1(config-rtr)# no shutdown

Router1(config)# ipv6 router eigrp 10

Router1(config-if)# ipv6 ospf 10 area 0.0.0.0

Router1(config-if)# ipv6 router rip 1

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
You have purchased a MAU (Multistation Access Unit) from your computer supplier and now must decide what type of network card you should install in the workstations. Which of the following would be the most appropriate?

Fast SCSI Wide

Token-Ring

None of these

ArcServe

Ethernet

Fast SCSI Wide

Token-Ring

None of these

ArcServe

Ethernet

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Which of the following is true when describing a unique local address?

These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4.

These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap.

These are like private addresses in IPv4 in that they are not meant to be routed.

Packets addressed to a unicast address are delivered to a single interface.

These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4.

These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap.

These are like private addresses in IPv4 in that they are not meant to be routed.

Packets addressed to a unicast address are delivered to a single interface.

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
What are two purposes for segmentation with a bridge?1. To add more broadcast domains.2. To create more collision domains.3. To add more bandwidth for users.4. To allow more broadcasts for users.

2 and 3

4 only

2 and 4

1 only

2 and 3

4 only

2 and 4

1 only

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking

Computer Networking When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

Computer Networking To enable RIPng, which of the following would you use?

Computer Networking You have purchased a MAU (Multistation Access Unit) from your computer supplier and now must decide what type of network card you should install in the workstations. Which of the following would be the most appropriate?

Computer Networking Which of the following is true when describing a unique local address?

Computer Networking What are two purposes for segmentation with a bridge?1. To add more broadcast domains.2. To create more collision domains.3. To add more bandwidth for users.4. To allow more broadcasts for users.

Computer Networking
When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

Computer Networking
To enable RIPng, which of the following would you use?

Computer Networking
You have purchased a MAU (Multistation Access Unit) from your computer supplier and now must decide what type of network card you should install in the workstations. Which of the following would be the most appropriate?

Computer Networking
Which of the following is true when describing a unique local address?

Computer Networking
What are two purposes for segmentation with a bridge?1. To add more broadcast domains.2. To create more collision domains.3. To add more bandwidth for users.4. To allow more broadcasts for users.