Manufacturing And Production Technology Jigs are used To check the accuracy of workpiece For holding and guiding the tool in drilling, reaming or tapping operations For holding the work in milling, grinding, planing or turning operations None of these To check the accuracy of workpiece For holding and guiding the tool in drilling, reaming or tapping operations For holding the work in milling, grinding, planing or turning operations None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A drill considered as a cutting tool having zero rake, is known as a Flat drill Straight fluted drill Tapered shank twist drill Parallel shank twist drill Flat drill Straight fluted drill Tapered shank twist drill Parallel shank twist drill ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The floating position of the holding fixture in a rotary transfer device is used to Reduce the tendency to over-index Improve the accuracy of location Reduce the cycle time Improve upon the acceleration and deceleration characteristics Reduce the tendency to over-index Improve the accuracy of location Reduce the cycle time Improve upon the acceleration and deceleration characteristics ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Climb milling is chosen while machining because Better surface finish can be obtained It enables the cutter to dig in and start the cut The chip thickness increase gradually The specific power consumption is reduced Better surface finish can be obtained It enables the cutter to dig in and start the cut The chip thickness increase gradually The specific power consumption is reduced ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tail-stock set over required to turn a taper on the entire length of a workpiece having diameters D and d is (D - d)/2 D - d (D - d)/2L (D - d)/L (D - d)/2 D - d (D - d)/2L (D - d)/L ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The lip angle is the angle Between the face of the tool and a line tangent to the machined surface at the cutting point Made by the face of the tool and the plane parallel to the base of the cutting tool Between the tool face and the ground end surface of flank None of the listed here Between the face of the tool and a line tangent to the machined surface at the cutting point Made by the face of the tool and the plane parallel to the base of the cutting tool Between the tool face and the ground end surface of flank None of the listed here ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS