Manufacturing And Production Technology In up milling, the thickness of chip is Maximum at the beginning of the cut and minimum at the end of the cut Uniform throughout the cut None of these Minimum at the beginning of the cut and maximum at the end of the cut Maximum at the beginning of the cut and minimum at the end of the cut Uniform throughout the cut None of these Minimum at the beginning of the cut and maximum at the end of the cut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A drill mainly used in drilling brass, copper or softer materials, is Straight fluted drill Tapered shank twist drill Flat drill Parallel shank twist drill Straight fluted drill Tapered shank twist drill Flat drill Parallel shank twist drill ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In down milling, the thickness of chip is Uniform throughout the cut Maximum at the beginning of the cut and minimum at the end of the cut Minimum at the beginning of the cut and maximum at the end of the cut None of these Uniform throughout the cut Maximum at the beginning of the cut and minimum at the end of the cut Minimum at the beginning of the cut and maximum at the end of the cut None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The size of a lathe is specified by the Swing diameter over the bed All of these Length between centers Swing diameter over the carriage Swing diameter over the bed All of these Length between centers Swing diameter over the carriage ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Calculate the weld per minute, work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. 600 welds/min, 1500 mm/min 3000 welds/min, 75 mm/min 22 welds/min, 55 mm/min 500 welds/min, 1250 mm/min 600 welds/min, 1500 mm/min 3000 welds/min, 75 mm/min 22 welds/min, 55 mm/min 500 welds/min, 1250 mm/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The percentage of carbon in gray cast iron is in the range of 3 to 4 percent 1.25 to 1.75 percent 8 to 10 percent 0.25 to 0.75 percent 3 to 4 percent 1.25 to 1.75 percent 8 to 10 percent 0.25 to 0.75 percent ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS