Manufacturing And Production Technology In ultrasonic machining, the metal is removed by Direct contact of tool with the work Using abrasive slurry between the tool and work Maintaining an electrolyte between the work and tool in a very small gap between the two Erosion caused by rapidly recurring spark discharges between the tool and work Direct contact of tool with the work Using abrasive slurry between the tool and work Maintaining an electrolyte between the work and tool in a very small gap between the two Erosion caused by rapidly recurring spark discharges between the tool and work ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology For turning small taper on long workpiece, the suitable method is By setting over the tail stock By a taper turning attachment By a form tool By swiveling the compound rest By setting over the tail stock By a taper turning attachment By a form tool By swiveling the compound rest ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the maximum chip thickness May not occur at the middle Depends upon the geometry of the tool Occurs at the middle Depends upon the material of the tool May not occur at the middle Depends upon the geometry of the tool Occurs at the middle Depends upon the material of the tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Down milling is also called Face milling End milling Conventional milling Climb milling Face milling End milling Conventional milling Climb milling ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool life is said to be over if All of these There is sudden increase in cutting forces and power consumption Poor surface finish is obtained Overheating and fuming due to heat of friction starts All of these There is sudden increase in cutting forces and power consumption Poor surface finish is obtained Overheating and fuming due to heat of friction starts ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The cutting force in punching and blanking operations mainly depends on The modulus of elasticity of metal The yield strength of metal The shear strength of metal The bulk modulus of metal The modulus of elasticity of metal The yield strength of metal The shear strength of metal The bulk modulus of metal ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS