Manufacturing And Production Technology In metal machining, the work-tool contact zone is a zone where heat is generated due to None of these Friction between the moving chip and the tool face Burnishing friction Plastic deformation of metal None of these Friction between the moving chip and the tool face Burnishing friction Plastic deformation of metal ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In up milling, the thickness of chip is None of these Uniform throughout the cut Maximum at the beginning of the cut and minimum at the end of the cut Minimum at the beginning of the cut and maximum at the end of the cut None of these Uniform throughout the cut Maximum at the beginning of the cut and minimum at the end of the cut Minimum at the beginning of the cut and maximum at the end of the cut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is 15 m/min 10 m/min 22 m/min 30 m/min 15 m/min 10 m/min 22 m/min 30 m/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In centre less grinders, the maximum angular adjustment of the regulating wheel is 10° 15° 20° 5° 10° 15° 20° 5° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The type of reamer used for reaming operation in a blind hole, is Any one of these Right hand spiral fluted reamer Straight fluted reamer Left hand spiral fluted reamer Any one of these Right hand spiral fluted reamer Straight fluted reamer Left hand spiral fluted reamer ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In ultrasonic machining, the metal is removed by Erosion caused by rapidly recurring spark discharges between the tool and work Direct contact of tool with the work Maintaining an electrolyte between the work and tool in a very small gap between the two Using abrasive slurry between the tool and work Erosion caused by rapidly recurring spark discharges between the tool and work Direct contact of tool with the work Maintaining an electrolyte between the work and tool in a very small gap between the two Using abrasive slurry between the tool and work ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS