Engineering Drawing In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right side views. Miter Hidden Object Dimension Miter Hidden Object Dimension ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When positioning this feature of perspective projection, the centerline of the cone of visual rays should be directed toward the approximate center of the object: Horizon Vanishing point Station point Ground line Horizon Vanishing point Station point Ground line ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing These weld symbols have no arrow-side or other-side significance: Projection or seam weld Flash and upset weld Surface or groove weld Back or backing weld Projection or seam weld Flash and upset weld Surface or groove weld Back or backing weld ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This type of section is not in direct projection from the view containing the cutting plane: Removed section Broken-out section Revolved section Full section Removed section Broken-out section Revolved section Full section ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________. Type 3 forward slash and enter Type 3 back slash and enter Type @3 Type 3 and try to use the Dynamic Input readout to find the end point Type 3 forward slash and enter Type 3 back slash and enter Type @3 Type 3 and try to use the Dynamic Input readout to find the end point ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The principle reason for using an auxiliary view is ________. To eliminate hidden lines To show cylinders as ellipses To create a true projection plane from an inclined plane in one of the primary views To locate center marks To eliminate hidden lines To show cylinders as ellipses To create a true projection plane from an inclined plane in one of the primary views To locate center marks ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS