Computer Networking
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.2. The VTP management domain name of both switches must be set the same.3. All ports on both the switches must be set as access ports.4. One of the two switches must be configured as a VTP server.5. A rollover cable is required to connect the two switches together.6. A router must be used to forward VTP traffic between VLANs.

1, 2 and 4
2 and 4
3, 5 and 6
1 and 6

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Your company is running IGRP using an AS of 10. You want to configure EIGRP on the network but want to migrate slowly to EIGRP and don't want to configure redistribution. What command would allow you to migrate over time to EIGRP without configuring redistribution?

router eigrp 11
router eigrp 10
router eigrp 10 redistribute igrp
router igrp combine eigrp 10

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
The physical layer, in reference to the OSI model, defines

All of these
the virtual circuit interface to packet-switched service
data link procedures that provide for the exchange of data via frames that can be sent and received
the interface between the X.25 network and packet mode device
None of these

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Which of the following is true when describing a global unicast address?

These are like private addresses in IPv4 in that they are not meant to be routed.
Packets addressed to a unicast address are delivered to a single interface.
These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap.
These are your typical publicly routable addresses, just like a regular publicly routable address in IPv4.

ANSWER DOWNLOAD EXAMIANS APP