Water Supply Engineering In centrifugal pump installation, Pump is properly primed before starting The diameter of the pipe at inlet as well as at outlet, is kept smaller than the delivery pipe The motor may burn out if it is started with empty delivery pipe and with open gate valve All listed here Pump is properly primed before starting The diameter of the pipe at inlet as well as at outlet, is kept smaller than the delivery pipe The motor may burn out if it is started with empty delivery pipe and with open gate valve All listed here ANSWER DOWNLOAD EXAMIANS APP
Water Supply Engineering The least thickness of class B cast iron (spun) pipe, is 7.9 mm 8.6 mm 7.2 mm 10 mm 7.9 mm 8.6 mm 7.2 mm 10 mm ANSWER DOWNLOAD EXAMIANS APP
Water Supply Engineering To pump water from a water reservoir 3 m deep and maximum water level at 135 m, a pump is installed to lift water up to R.L. 175 m at a constant rate of 36,00,000 litres per hour. If the length of the pipe is 1506 m and f = 0.01, ignoring other minor losses and assuming the economical diameter from Lea's formula D = 1.2 √Q, the water horse power of the pump is 450 400 500 600 450 400 500 600 ANSWER DOWNLOAD EXAMIANS APP
Water Supply Engineering In pressure supply mains, water hammer pressure is reduced by providing Air valves Sluice valves Pressure relief valves None of these Air valves Sluice valves Pressure relief valves None of these ANSWER DOWNLOAD EXAMIANS APP
Water Supply Engineering The specific retention is least in case of Clay Sand Silt Coarse gravel. Clay Sand Silt Coarse gravel. ANSWER DOWNLOAD EXAMIANS APP
Water Supply Engineering When the reduced level of the water source is higher than the reduced level of the consumer's place, water is generally supplied Both (A) and (B) By gravitational system All listed here By pumping system Both (A) and (B) By gravitational system All listed here By pumping system ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS