Workshop Technology In backhand welding, the angle between the welding torch and the work is kept as 40°-50° 60°-70° 50°-60° 30°-40° 40°-50° 60°-70° 50°-60° 30°-40° ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The process of increasing the cross-section of a bar at the expense of its length, is called Upsetting Drawing down Spinning Peening Upsetting Drawing down Spinning Peening ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The mode of deformation of the metal during spinning is Bending Rolling and stretching Bending and stretching Stretching Bending Rolling and stretching Bending and stretching Stretching ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Structural sections such as rails, angles, I-beams are made by Hot extrusion Hot piercing Hot rolling Hot drawing Hot extrusion Hot piercing Hot rolling Hot drawing ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology When the dimension is expressed as 20 -0.025 ⁺⁰∙⁰³⁵, then the basic size is 19.975 mm 20.035 mm 20 mm 20.025 mm 19.975 mm 20.035 mm 20 mm 20.025 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The advantage of Thermit welding is that All parts of the weld section are molten at the same time All of these Weld cools almost uniformly Results in a minimum problem with internal residual stresses All parts of the weld section are molten at the same time All of these Weld cools almost uniformly Results in a minimum problem with internal residual stresses ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS