Chemical Engineering Basics Ignition of fuel in a diesel engine is by Spark None of these Hot compressed air Fuel injection Spark None of these Hot compressed air Fuel injection ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Principal alloying elements of cast tool alloys which have very high wear resistance & high temperature strength are Cobalt, chromium & nickel Cobalt, chromium & tungsten Molybdenun, tungsten & chromium Cobalt, zirconium & molybdenum Cobalt, chromium & nickel Cobalt, chromium & tungsten Molybdenun, tungsten & chromium Cobalt, zirconium & molybdenum ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Area under the stress-strain curve upto the __________ is referred to as the modulus of resilience. Maximum point Yield strength Elastic limit Proportional limit Maximum point Yield strength Elastic limit Proportional limit ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Out of the following, which will fracture most readity, when hit with a hard hammer ? Bronze Cast iron German silver Brass Bronze Cast iron German silver Brass ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics __________ is the hardest oxide and is hence used where high wear resistance at high temperature is required. Zirconia Beryllia Magnesia Alumina Zirconia Beryllia Magnesia Alumina ANSWER DOWNLOAD EXAMIANS APP
Chemical Engineering Basics Friction factor for fluid flow in pipe does not depend upon the Pipe roughness Fluid density & viscosity Pipe length Mass flow rate of fluid Pipe roughness Fluid density & viscosity Pipe length Mass flow rate of fluid ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS