Manufacturing And Production Technology If the cutting speed is increased, then the built-up-edge Has nothing to do with speed Becomes longer May or may not form Becomes smaller and finally does not form at all Has nothing to do with speed Becomes longer May or may not form Becomes smaller and finally does not form at all ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The swing diameter over the bed is ________ the height of the centre measured from the bed of the lathe. Twice Equal to Thrice One-half Twice Equal to Thrice One-half ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is Diamond pin locator Conical locator Cylindrical locator Vee locator Diamond pin locator Conical locator Cylindrical locator Vee locator ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The stroke of a shaping machine is 250 mm. It makes 30 double strokes per minute. The overall average speed of operation is 5 m/min 7.5 m/min 3.75 m/min 15 m/min 5 m/min 7.5 m/min 3.75 m/min 15 m/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The cutting force in punching and blanking operations mainly depends on The yield strength of metal The bulk modulus of metal The shear strength of metal The modulus of elasticity of metal The yield strength of metal The bulk modulus of metal The shear strength of metal The modulus of elasticity of metal ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The cutting angle of a flat drill varies from 20° to 30° 90° to 120° 60° to 90° 3° to 8° 20° to 30° 90° to 120° 60° to 90° 3° to 8° ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS