Mechanical Operations Hot, lumpy & abrasive materials are best transported by using a/an __________ conveyor. Apron Belt Screw Flight Apron Belt Screw Flight ANSWER DOWNLOAD EXAMIANS APP
Mechanical Operations In screen analysis, the notation +5 mm/-10 mm means particles passing through 10 mm screen and retained on 5 mm screen Both 5 mm and 10 mm screens 5 mm screen and retained on 10 mm screen Neither 5 mm nor 10 mm screen 10 mm screen and retained on 5 mm screen Both 5 mm and 10 mm screens 5 mm screen and retained on 10 mm screen Neither 5 mm nor 10 mm screen ANSWER DOWNLOAD EXAMIANS APP
Mechanical Operations The sphericity of a cylinder of 1 mm diameter and length 3 mm is 0.5 0.9 0.6 0.78 0.5 0.9 0.6 0.78 ANSWER DOWNLOAD EXAMIANS APP
Mechanical Operations Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter) 2 D D 1.5 D 0.5 D 2 D D 1.5 D 0.5 D ANSWER DOWNLOAD EXAMIANS APP
Mechanical Operations For coarse reduction of hard solids, use Cutting Compression Attrition Impact Cutting Compression Attrition Impact ANSWER DOWNLOAD EXAMIANS APP
Mechanical Operations To remove dirt from the flowing fluid, we use a Gravity settler Clarifier Strains Coagulant Gravity settler Clarifier Strains Coagulant ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS